Decal Art Submission & Installation Instructions
Artwork Submission Details
Please email all customised artwork to dsolomonltd@gmail.com
Print a whole sheet of decals on a 43 x 27 cm sheet. If you want multiple decals, please fill the artwork sheet with however many decals you want (see example below). Please allow 5mm spacing between each decal and 5mm from the edges of the sheet. Send document to the email above.
Ideally, the document needs to be saved as a pdf with vector made decals. Alternatively, if easier to you, you can make the decal document a PNG with a 300 dpi. All decals need to have a transparent background, otherwise a white background will appear. Please avoid sending the document as a jpeg as this type of document will not have a transparent background on the printed decal sheet.
At its smallest, each decal can have a minimum diameter of 1mm. Maximum size decal can fit this sheet provided 5mm are left between the decal and sheet edges. Please make sure the colour is set to CMYK (cyan, magenta, yellow, black) not Pantone.
If you wanted a wasp decal in a size such as 20mm, it would be preferred that you send us the artwork full of wasps, and not just one wasp with a "send me as many as fit for 20mm diameter each decal" however we can do this for you at a cost of £10 once. To add this addition to your cart click here
Example Sheet - this is how your artwork submission doc should looK:
Decal Application Details
Before applying the decal please clean your hands with a wipe. Cut up the individual decals before peeling, please allow 2-5mm spacing from the decal edge. Lay the Decal sheet on a hard surface with the white side facing up.
Begin to peel the upper, stiffer layer carefully whilst the white side of the decal is facing up. Peel from one corner to another.
Once fully peeled, apply to a hard-surfaced object from one corner to another. Apply consistent pressure to the decal and fix it to the hard surface slowly to avoid creating air bubbles. Once fully stuck to the object, carefully remove the remaining laminate layer. After this, you're good to go!